JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.
We appreciate your confidence in our IceCap product. If for any reason you are missing, have an issue with the product, or just have a simple question, please get in touch with our support staff at support.coralvue.com.
These instructions are dedicated to all three IceCap Flow Pump models, including FP-60, FP-100, and FP-200. Please keep the magnet base away from children.
- Flow Pump with Mounting Magnet - Inline Flow Controller- Power Supply
Please remember the following pump installation instructions:
1. Locate and clean the surface area where you intend to install the pump.
2. Position the Inner Magnet Mount and the Dry Side Mount in your preferred location. Be cautious not to let the two magnets snap together when mounting.
3. Attach the pump to the inner magnet, ensuring that the power cable is facing upwards.
WARNING: The creation of waves within the aquarium can place excessive stress on the aquarium and its seams. Not all aquariums can withstand stress produced by waves. We are not responsible for any damage to the surrounding environment or indirect damage caused by the production of waves within the aquarium.
Please ensure that you mount the controller in a dry location within reach of the flow pump using screws (not included). Make sure to leave a drip loop between the controller and the pump. Next, plug the power supply into the power port of the controller and then plug the other end into your home receptacle.
We recommend cleaning the pump every 2-3 months or as necessary, using a high-quality pump cleaner or citric acid.
Here are the instructions in a clearer format:
1. Carefully remove the pump from the inner magnet base.2. To remove the flow cage, rotate it slightly counter-clockwise and away from the pump body.3. To remove the impeller, rotate the impeller base counterclockwise and pull away from the pump body to expose the impeller magnet and rear shaft assembly.